50 t balų presas, 22 kW variklis su wirbulatoriumi

Presona LP 50 EH1

Technical Data Baler:

Manufacturer: Presona AB
Model: LP 50 EH1
Year of manufacture: 2005
Operating hours: 30,408 hours (as of April)
Number of bales produced: 198,059 pcs (as of April)
Main press force: 50 t
Specific pressing force: 63 N/cm²
Theoretical throughput: 530 m³/h
Throughput under working conditions: 260 m³/h
Feed opening dimensions: 1,250 x 1,100 mm
Chamber volume: 2.2 m³
Bale dimensions: 1,100 x 720 mm (variable length)
Drive power: 22 kW
Tying: 5-fold vertical, fully automatic
Throughput capacity at bulk density of:
- 30 kg/m³: 6 to 7 t/h
- 50 kg/m³: 7 to 9 t/h
- 100 kg/m³: 11 to 14 t/h
Bale density (paper/newspapers): 400 to 550 kg/m³
Hydraulic oil tank volume: 600 L
PLC: Telemecanique TSX Micro
Control panel: Schneider Magelis
Effective transport dimensions excl. press: 8,125 x 2,300 x 3,000 mm (L x W x H)
Transport weight press: approx. 16 t

Condition of the baler:
The machine has been partially overhauled in our workshop and general maintenance work has been carried out. After completion of the overhaul, the baler was tested during operation and is available for sale at short notice.

The following overhaul work was performed:

General Work:
- Machine cleaned, derusted, primed, and partially painted
- Wire ingress marks in the press channel welded and smoothed

Hydraulic Unit:
- Hydraulic oil tank drained, tank cleaned, filled with new oil
- Oil and air filters replaced
- Leaking oil sight glass on the tank replaced
- All hydraulic hoses replaced

Electrical System:
- Program menu language set to English
- Two key switches on the control panel replaced
- Control cabinet replaced
- Signal lamp on control cabinet replaced
- Flap limit switch replaced
Njdpfxey R Npij Afxswg
- Electrical system for the agitating device renewed, connected, and tested

Press Ram:
- All four press ram guide rollers removed and replaced
- Main hydraulic cylinder dismantled, disassembled and partially overhauled (cylinder barrel honed, complete seal kit replaced, tightness test performed)
- All plastic wear pads on the press ram replaced

Pre-press Flap:
- Both bearings on the pre-press shaft replaced
- Both hydraulic cylinders dismantled, disassembled and partially overhauled (cylinder barrels honed, complete seal kits replaced, tightness test performed)
- Scraper flap on the pre-press renewed

Tying System:
- Two complete needles with wire guide rollers replaced
- Needles adjusted and set
- All wire guide rollers in the needle heads replaced
- Twister finger replaced
- Two twister shafts replaced
- All 8 wear plates on the twister unit below the twister fingers replaced

Scope of delivery:
Only the baler is being sold.

Complete documentation (operating manual, CE declaration, electrical/hydraulic diagram) is available. Inspection is possible by appointment. We do not assume liability for the technical specifications or possible errors.

Skelbimas buvo automatiškai išverstas. Galimos vertimo klaidos.