Šaltas diskinis pjūklas

MEP TIGER 352 NC 5.0

MEP TIGER 352 NC 5.0 [Fully Automatic]

Article Number: TI352NC
Motor Power: 3.0 kW
Vice Opening: 190 mm
Blade Dimensions: 350x32x2.5 mm
Weight: 680 kg
Blade Speed: 15 - 90 m/min.
Cutting Capacity 0°: 115 / 95 / 180x95 mm
Cutting Capacity 45° Right: 110 / 95 / 125x95 mm
Cutting Capacity 45° Left:
Cutting Capacity 60° Right:
Cutting Capacity 60° Left:

Description
Electropneumatic, vertical, linear-guided automatic saw for the use of HSS saw blades, suitable for series cuts from 60° left to 45° right on steel. The machine also operates in semi-automatic mode. CNC automatic machine with multiprocessor and two axes controlled by MEP’s latest-generation CNC system, enabling programming of up to 1,000 different cutting programs—each with different lengths and quantities—for the same material thickness.

FEATURES:
- New centralized control console on an articulated arm for easy emergency stop access from any working position.
- NEW: Fieldbus communication system (Modbus protocol) with dual microprocessor and serial connection.
Fodschhhdopfx Acuspn
- Display with 20 characters x 4 lines showing technical parameters: + Blade speed + Number of programmed and completed cuts + Blade thickness + Feed length + Cutting time + Ammeter + Indication of over 100 diagnostic and warning messages.
- NEW: Display and logging of alarm and fault messages with incident review capability.
- NEW: 600 mm material feed with stepper motor and ball screw mounted on opposing bearings.
- NEW: Electronic inverter for continuous regulation of blade speed from 15 – 90 rpm (optional 30 to 150 rpm).
- NEW: Low-voltage control panel: Polyurethane membrane keypad with thermoformed, raised buttons and actuation confirmation signal.
- Double gear set for high cutting performance.
- Saw head glides on dual linear guideways with recirculating ball bearings.
- Coaxial cylinder with bypass valve for rapid approach and potentiometric linear transducer for head position detection.
- Programmable saw arm stroke from the control panel for adaptation to material size.
- Adaptive cutting pressure control.
- Rotating table with central pin and axial bearing for precise miter cuts.
- Pneumatic vertical vice.
- Electric coolant pump for blade cooling and lubrication.
- Chip removal brush.
- Signal lamp for program end or emergency stop.
- HSS saw blade Ø 350 x 32 x 2.5 mm, suitable for solid and profile material.
- Prepared for installation of a minimum quantity lubrication system (OPTIONAL), in addition to the standard emulsion oil lubrication system.

For further technical data, please refer to the attached PDF document.

Skelbimas verčiamas automatiškai, todėl jame gali būtų vertimo klaidų.