Presas su 8 kartus kryžminiu rišimu

Presona AB LP 80 VHK 1

Technical Data – Baler:

Manufacturer: Presona AB
Model: LP 80 VHK 1
Year of Manufacture: 2012
Ijdpfx Asvwlqqeauoia
Total Operating Hours (Machine): 25,895 hours (as of July 2025)
Effective Operating Hours (Pump): 14,135 hours (as of July 2025)
Number of Bales Pressed: 235,597 (as of July 2025)
Main Pressing Force: 78.5 t
Specific Pressing Force: 95 N/cm²
Pre-Press Force: 28 t
Press Chamber Volume: 2.7 m³
Feed Opening Dimensions: 1,500 x 1,100 mm
Theoretical Throughput: 930 m³/hour
Throughput Under Operating Conditions: 410 m³/hour
Bale Dimensions: 750 x 1,100 mm
Drive Power: 55 kW
Tying: 5-fold vertical, 3-fold horizontal, fully automatic
Throughput at Bulk Density of:
- 30 kg/m³: approx. 9 to 12 t/hour (material dependent)
- 50 kg/m³: approx. 14 to 17 t/hour (material dependent)
- 100 kg/m³: approx. 16 to 25 t/hour (material dependent)
Throughput at MSW (Municipal Solid Waste): approx. 20 to 27 t/hour (material dependent)
Bale Weights: 450 to 600 kg (depending on material and bale length)
Hydraulic Oil Tank Volume: 1,000 L
Baler Dimensions (assembled with hopper): 10,985 x 3,750 x 4,310 mm (L x W x H)
Transport Dimensions (baler only): 10,985 x 2,300 x 2,900 mm
Machine Weight (baler): approx. 24 t

Condition of the Baler:
The machine was partially overhauled and serviced in our workshop and, upon completion of the work, tested in both manual and automatic modes during operation.

The following overhaul work was carried out:
- Machine cleaned, partially derusted and partially repainted
- Hydraulic oil tank completely drained and cleaned
- Oil and air filters replaced, new hydraulic oil filled
- Press ram dismantled and cleaned
- All four running rollers removed from the press ram and replaced
- Twisting wire station with lower wire deflection pulleys cleaned and made operational
- Side guides of press ram removed, smoothed, re-installed, and re-adjusted
- Main hydraulic cylinder dismantled and disassembled for inspection
- Piston rod replaced, cylinder tube honed
- Complete seal set replaced, pressure test carried out
- Hydraulic hose of main hydraulic cylinder replaced
- Vertical and horizontal needle systems for tying dismantled, cleaned, wire deflection pulleys made operational and serviced
- Chain cleaned, lubricated, chain tension readjusted
- Drillomat cleaned, wire cutters, twisting shafts, and twisting fingers checked, retightened with appropriate torque, and serviced
- Door contact switch checked and partly replaced
- Emergency stop switch checked
- Complete electrical wiring checked and partly renewed
- Bearings of the wire guide rollers under the press replaced
- New safety guards for vertical and horizontal tying manufactured and installed
- Machine inspected, general maintenance performed, and baler tested in manual and automatic mode

Scope of Delivery:
Only the baler is being sold.

Remarks:
Full documentation is available (operating manual, CE declaration, electrical/hydraulic circuit diagram). Inspection by appointment is possible. No liability is assumed for technical specifications or possible errors.

Skelbimas buvo automatiškai išverstas. Galimos vertimo klaidos.