Bevel gear testing machine

Gleason BGT 200 H-W

The Gleason BGT 200 H-W universal bevel gear testing machine is used for roll-off, load capacity, and run-out testing, as well as for measuring backlash on the flank, installation dimensions, and sensitivity to displacement in bevel gears with and without axial offset and axial angles from 0° to 180°.
Gear sets with a maximum ring gear diameter of up to D=190.5 mm and hypoid gear sets with a pinion offset of 31.75 mm above and below the center can be tested.
This testing machine is ideally suited for testing gear sets with small diameters and small modules under low load and with a minimum of backlash.
The digital actual value display facilitates quick and precise adjustment and reading of the pinion installation dimension, ring gear installation dimension, and axial offset.
The motorized drive of the pinion spindle, in conjunction with the frequency converter, allows for stepless adjustment of the pinion speed in the range of 0 to 3,000 [rpm].
The work area is secured by an electrically interlocked safety device.

Technical data
Largest gear diameter 190.5 mm
Largest axial offset (hypoid offset) above (+) and below (-) the center ± 31.75 mm
Chjds Afi Atspfx Apajd
Largest / smallest distance from the machine center to the spindle nose, ring gear 177.8 / 0 mm
Largest / smallest distance from the machine center to the spindle nose, pinion 177.8 / 25.4 mm
Smallest / largest axial angle (steplessly adjustable) 0 to 180 °
Pinion and gear spindle:
Diameter at the large end 45.65 mm
Taper 1 : 24
Length of the taper 76.20 mm
Diameter of the spindle bore, throughout 33.33 mm
Speed range of the pinion spindle (steplessly adjustable) 0 to 3,000 rpm
Weight 1,050 kg
Dimensions L x W x H 500 x 1,100 x 2,000 mm

Skelbimas buvo automatiškai išverstas. Galimos vertimo klaidos.