HBC 110 K / 75 kW

Bollegraaf Recycling Solutions B.V. HBC 100 K

For sale is a refurbished baler with 100 t pressing force, large format 1100 x 1100 mm, 75 kW drive power, and a 10-fold cross-tying system.

Technical Data – Baler:
Manufacturer: Bollegraaf
Model: HBC 110 K / 75 kW
Year of manufacture: 2007
Main press force: 100 t
Prepress force: 50 t
Operating hours: 22,605 h
Feed opening dimensions: 1,600 x 1,100 mm
Filling volume per press cycle: 3.15 m³
Theoretical cycle time: 19 seconds
Bale dimensions: 1,100 x 1,100 mm
Drive power: 75 kW
Connected load: 126 kW
Total current consumption: 238 A
Tying: 5-fold vertical, 5-fold horizontal, fully automatic
Throughput rates at a
Bulk density of 30 kg/m³: approx. 16 t/h
Bulk density of 50 kg/m³: approx. 25 t/h
Crodpfevf E Avsx An Hjc
Bulk density of 100 kg/m³: approx. 47 t/h
Bale weights up to 1,400 kg, depending on material and bale length
Oil tank capacity: approx. 1,300 l
PLC: Telemecanique TSX Micro
Operator panel: Schneider MAGELIS Touch
Baler dimensions assembled with hopper: 11,750 x 5,000 x 7,105 mm (L x W x H)
Transport dimensions baler only: 11,765 x 2,500 x 3,450 mm (L x W x H)
Machine weight baler: approx. 36 t

Remarks:
The baler has been partially refurbished, serviced in our workshop, tested after completion, and stored. The machine is available at short notice and can be inspected at our warehouse by appointment.

The following refurbishment works have been carried out:
- Derusting and partial repainting of the baler
- Complete draining of the hydraulic oil tank, replacement of oil and air filters
- Refilled with new hydraulic oil
- Replaced all hydraulic hoses
- Disassembled, overhauled, and reassembled main hydraulic cylinder, two pre-press flap cylinders, and channel press cylinder: honed cylinder tubes, renewed all seal kits, and carried out final pressure test
- Dismantled pre-press flap with bearings and bearing brackets. Removed and re-welded 1st and 3rd arc segment
- Renewed both bearings on pre-press flap shaft
- Renewed upper material retainer on pre-press flap frame
- Dismantled the press ram, inspected and replaced both front running wheels
- Removed and replaced material retainers and wear profiles on sides and bottom of the press ram
- Dismantled, overhauled horizontal and vertical needle and tying units, replaced plastic sliding plates, bearings for twister shafts and wire guide pulleys on the needle heads
- Replaced both bronze slide rails left and right in press ram frame cover
- Renewed both wire redirect units left and right, incl. bale retention clamps
- Fully renewed wire feeding unit incl. hydraulic cylinder under the needle passages
- Welded and smoothed out wire grooves on the bottom and side walls of the press channel
- General maintenance and service work according to manufacturer’s recommendations
- Baler tested in both manual and automatic mode after completion of refurbishment, accepted and stored

All technical information is provided without liability for errors or omissions.

Skelbimas buvo automatiškai išverstas. Galimos vertimo klaidos.