Balių presas 60 t

Presona AB LP 60 VH1

Technical Data of the Baler:
Manufacturer: Presona AB, Sweden
Model: LP 60 VH1
Year of Manufacture: 2015
Total Operating Hours: 30,143 hours (as of July 2025)
Actual Pump Runtime: 6,527 hours (as of July 2025)
Number of Bales Pressed: 115,193 bales (as of July 2025)
Pre-Press Force: 25 t
Nodey S Rtljpfx Afxjwg
Main Press Force: 60 t
Specific Press Force: 73 N/cm²
Feed Opening Dimensions: 1,500 x 1,100 mm
Filling Volume per Press Cycle: 2.7 m³
Theoretical Throughput: 800 m³/hour
Throughput Under Operating Conditions: 350 m³/hour
Bale Dimensions: 1,100 x 750 mm
Drive Power: 37 kW
Tying System: 5-fold vertical, fully automatic
Throughput at a Bulk Density of 50 kg/m³: 11 to 14 t/hour
Bale Weights: 420 to 570 kg, depending on material
Hydraulic Oil Tank Volume: 600 L
Baler Dimensions Assembled with Hopper: 10,100 x 3,750 x 4,310 mm (L x W x H)
Transport Dimensions (excluding press): 10,100 x 2,400 x 3,000 mm (L x W x H)
Machine Weight (Press): approx. 20 t

Condition of the Baler:

The baler has been partially overhauled in our workshop and subsequently tested in manual and automatic operation.

The following overhaul work was carried out:
- Machine cleaned, partially de-rusted and partially repainted
- Hydraulic oil tank fully drained and cleaned
- Oil and air filters replaced, new hydraulic oil filled
- Press ram disassembled and cleaned
- All four press ram rollers disassembled and renewed
- Grease cartridges of the automatic roller lubrication system replaced
- Guide rails on the baler floor in the pressing chamber cut out
- Floor reinforced with welded plates
- New HARDOX guide rails welded in
- Wire station and deflection pulleys for lower wire cleaned and serviced
- Guide rails from the floor of the press channel cut out
- New HARDOX guide rails welded in
- Both side walls of the press channel disassembled and de-rusted
- Worn side wall plates removed
- Complete side walls fitted and welded with new wear plates
- Main hydraulic cylinder disassembled and overhauled for inspection
- Piston rod replaced, cylinder tube honed
- All sealing sets replaced, pressure test performed
- Vertical needle system for tying disassembled, cleaned, wire deflection pulleys serviced and maintained
- Chain cleaned, greased, tension readjusted
- Drillomat cleaned, wire cutter, drilling shafts and drilling fingers checked, retorqued, and serviced
- Machine inspected, general maintenance work carried out, and baler tested in both manual and automatic operation

Remarks:
The baler is sold without a conveyor belt and without wire stations. Inspection is possible by prior arrangement. We assume no liability for the technical specifications or any errors.

Skelbimas buvo automatiškai išverstas. Galimos vertimo klaidos.