Vielinio erozijos staklės (Wire-Cut EDM)

Mitsubishi MV2400R

Wire-Cut EDM Machine

The machine comes from productive use and is in functional, used condition. All relevant assemblies are complete; the generator cabinet, control system, wire feed, and AT system (automatic wire threader) are all present.

Operating times according to the controller:
- Machining time: approx. 29,062 h
- NC power-on time: approx. 43,836 h
- Ready/TFT downtime: approx. 8,966 h

Maintenance intervals (extract):
- Filter change: last performed at 176 h / every 200 h
- Resin replacement: 21 h / every 1,000 h
- Oil refill: 742 h / every 1,000 h
- Conductivity sensor: 742 h / every 1,000 h
- Power feeder rotation: 57 h / every 80 h

The machine is complete, but shows typical signs of use after 10+ years in operation.
Accessories are extensive and well organized.
Scheduled maintenance regularly confirmed per control system.
Automatic wire threading available.

Accessories / Equipment:
- Original Mitsubishi Nozzle & Roller/Bearing Kit:
Nedpfxjx Hadvo Ag Helf
- Various guide rollers
- Upper and lower diamond guides
- Nozzle set (upper/lower)
- Deburring stones / assembly tools
- NSK/Japan replacement bearings
- Replacement tension rollers
- Mitsubishi Electric manufacturer’s wooden box
- Spare and consumables:
- Resin container (sealed)
- Filter cartridges
- Instant adhesive, components A/B
- pH test strips
- EDM process chemistry
- Logbook / maintenance documents
- Documentation:
- Complete binders: MV Manual Part 1 & 2
- “Advance Series” training materials
- Operating instructions (German)
- Maintenance and AT maintenance sheets

Travel distances (X / Y / Z):
600 × 400 × 310 mm

Worktable / working area:
- Table size: 840 × 640 mm (square table)
- Max. workpiece dimensions: 1050 × 800 × 295 mm
- Max. workpiece weight: 1500 kg

Wire data:
- Wire diameter: 0.1–0.3 mm
- Max. wire feed: 23 m/min
- Tension: 0.5–25 N
- Automatic threading (AT), incl. fine threading

Taper machining:
- Opto-linear T/C unit,
- ±75 mm (X/Y), max. taper angle 15° at 260 mm workpiece height

Generator / Control:
- Transistor-controlled pulse generator
- 15" LCD touch controller
- 6 axes simultaneous
- Integrated 2D and 3D CAM (Parasolid Viewer)
- NC storage up to 1 GB
- USB interfaces (2×)

Dielectric system:
- Tank volume: 860 l
- Filter flow rate: 50 l/min
- Paper filters (2 units)
- Resin container 10 l (ion exchanger)

Skelbimas buvo automatiškai išverstas. Galimos vertimo klaidos.