Termoformavimo mašina

Illig UA 100 4G Solo/ BE

Max. forming area: 960 x 660 mm
Min. forming area: 210 x 170 mm
Max. sheet size: 1000 x 700 mm
Min. sheet size: 310 x 210 mm
Max. sheet thickness (manual loading): 12 mm
Max. sheet thickness (automatic loading): 10 mm
Max. tool height: 490 mm
Max. draw depth: 300 mm (positive/negative)
Total connected load: approx. 64.0 kW / 115 A

Technical features:
- Siemens Simatic S7-300 control system, OP 37 panel
- Climate-controlled control cabinet
- Top heater with 5 temperature control circuits via pilot emitters
- Bottom heater with 5 temperature control circuits via pilot emitters
- Individual emitter control for both top and bottom heaters
Dkedpfx Afjwf Dvae Hsu
- Parallel clamping frame
- Locking of upper reduction frames via pneumatic motor
- Locking of lower reduction frames via cylinders
- 4 cooling fans
- Table vacuum adjustable via cascade circuit
- Pre-blow and demolding adjustable via cascade circuit
- Large front opening for tool change
- Film sag monitoring by photocell with support air
- Automatic tool change system

Lower table:
1. Tool clamping by vacuum
2. Tool change via pneumatically operated ball rollers

Upper punch:
1. Motorized remote adjustment for stroke limitation
2. Pneumatic quick-release tool clamping system

Sheet feeding:
- Automatic lifting of the film transport chain by motor
- Pneumatic quick-change system for suction plates
- Motorized centering of plastic sheets
- Separate vacuum pump for grained material

Optional retrofit: Preheating system:
- Pneumatically operated top heater, overall field control, individual emitters can be switched on/off via toggle switches
- Pneumatically operated bottom heater, overall field control, individual emitters can be switched on/off via toggle switches
- Temperature control of top and bottom heaters via separate controllers in the BE control cabinet (temperature setting not via operator panel of UA)

Optional retrofit for roll processing:
- Cross cutter and feed rollers in feeder
- Roll stand RO 800

Skelbimas verčiamas automatiškai, todėl jame gali būtų vertimo klaidų.