Karštos kameros liejimo mašina - Vertikali

FRECH DAW 80S

Clamping force: 900 kN
Clamping platen: 540 x 540 mm
Distance between tie bars: 350 x 350 mm
Machine weight: approx. 5.5 t
Clamping stroke: 280 mm
Ejector force: 60 kN
Ejector stroke: 70 mm
Dusdpfx Acjyzt D Ej Dor
Mould height: 160–400 mm
Tie bar diameter: 65 mm
Casting force: 75 kN
Casting stroke: 130 mm
Casting piston diameter: 50, 55, 60 mm
Casting volume (DIN 24480): 119, 163, 214 cm³
Specific casting pressure: 380, 315, 265 kp/cm²
Corresponding parting surface: 236, 285, 340 cm²
Downstroke: 150 mm

Completely overhauled DAW 80 GO die casting machine with DataLogic control system for use with zinc alloys.

Excerpt from the general overhaul:
· Upgrading the machine with a new control cabinet and new operator panel,
including replacement of all electrical wiring.
· Renewal of hydraulics (blocks and valves).
· Overhaul of the clamping unit.
Detailed list available upon request.

The machine is equipped with the following options:
- Motor-driven safety door, casting direction left
- Discharge chute cover on the machine base (straight)
- Free-standing operator panel
1.0.2 Discharge chute cover for machine base
3.2.4 Multi-chamber holding and melting furnace with TOC pump
3.2.1 Furnace control cabinet for furnace type Z
4.0.1 Use of water-glycol
4.2. – Side GO
6.1.3.1 Wired signal interface for part removal (DISPO10)
6.5.2 RSD equipment package with switch
7.2.2.2 Spraymotion 611 E with servo drive, single-circuit
7.3.1 Release agent container TD 20
7.4.0.3 Spray bar CR 275

Additional options are available upon request.

Skelbimas buvo automatiškai išverstas. Galimos vertimo klaidos.