Kiti

Fliegl SZS 260 Jumbo mit Radmulden und Tiefbett für LKW

Further information
Chassis semitrailer forwarding
Welded fine-grained steel construction, fifth wheel plate with replaceable 2 kingpins, rear bevel to approx. 1920 mm, suspension bar for ramps at the rear and front on gooseneck, grinding rollers at the rear, drop center after cranking up to the axle unit. Drawing approval required from customer in case of order!
Pair of lashing lugs at the top and side of the outer frame, 10 tons each
Pair of lashing eyes embedded in the outer frame on gooseneck, 5 tons each
24 to. 2-speed support winch, single-side operation, with straight lower section, without thrust compensation
Folding rear support, mounted on the outside
Lodpfxji Ri Hrj Agfohd
Wheel chocks with holder
Aluminum side collision protection
Steel underride guard for EG, if technically possible
Quarter-shell mudguards
with anti-spray flaps according to EG
1 pair of wheel recesses after gooseneck recessed in the low bed of the tramline area, sloping towards the entrance. Length at bottom approx. 1840 mm, depth of wheel recesses approx. 200 mm. 2nd pair of wheel recesses on rear slope. Depth approx. 200 mm. Note! Frame in main beam area 200 mm higher than wheel recess. In the event of an order, a precise technical inspection is still required.
Wheel recess cover can be pulled out from the drop deck with hardwood inserts, on rear slope with hardwood inserts.
Electric cable winch, 24 volt, pulling force 5500 kg, mounted in the offset gooseneck, not reaching into the loading area, operation with radio remote control, operation with radio remote control, cable length 35 m x approx. 10 mm, with roller cable window and removable guide roller on rear slope.
Axles + suspension
SAF or BPW drum brake axles of our choice
Air suspension with lift & lower valve + auto-reset function
Wheels and tires
205 / 65 R 17.5 tires with 129/127K (132/132G) marking for 8 to tire load capacity at max. 90 km/h
at the manufacturer's discretion
Twin steel rims, factory silver
Brake system
2-line compressed air brake system
Spring-applied parking brake
2 interchangeable clutch heads at the front, without connecting cable
EBS make Haldex, electronic brake system with EBS socket at the front, without connecting cable (sent to the customer for approval brake calculation.15.07.2021)
Attention: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS!
Axle load detection via EBS-Canbus signal, for display via display in the cab, truck must be prepared accordingly, no truck instal. (no calibrated scales)
Electrical system
24 volt, multi-chamber lights, amber LED lighting on the side
2 white position lights at the front
2 white/red lane departure lights at the rear
2 x 7-pin and 1 x 15-pin interchangeable sockets at the front, without connecting cable
Floor
Gooseneck with steel / checker plate covering
30 mm screen-printed floor, in the drop floor between the longitudinal beams in the middleIn the tramline area covered with toothed grating in the wheel recesses with steel/checker plate covering.
Access ramps
Pair of aluminum ramps 3,200 mm long, load capacity per pair 12,000 kg
Pair of steel ramps for entering the drop deck
Pair of steel ramps for crossing on gooseneck
Drop sides
Approval / plates
Country of approval: Germany
with Dekra approval and expert opinion (according to §13 EG - FGV)
Prepared for single-line license plate holder
Contour markings with reflective strips to ECE R 048, yellow at the sides and red at the rear
Warning sign according to ECE -

Skelbimas buvo automatiškai išverstas. Galimos vertimo klaidos.